Porter-Cable PC600JS - Understanding Tool Symbols

4
layontheskinmaypromoteabsorptionofharmfulchemicals.
WARNING: ALWAYS use safety glasses. Everyday eyeglasses are NOT safety
glasses. Also use face or dust mask if drilling operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSIZ87.1eyeprotection(CAN/CPAZ94.3),
• ANSIS12.6(S3.19)hearingprotection,
• NOSH/OSHArespiratoryprotection.
WARNING: Use of this tool can generate and/or disperse dust, which may
cause serious and permanent respiratory or other injury.AlwaysuseNIOSH/OSHA
approvedrespiratoryprotectionappropriateforthedustexposure.Directparticles
away from face and body.
CAUTION: Wear appropriate hearing protection during use. Under some con-
ditions and duration of use, noise from this product may contribute to hearing loss.
SAVE THESE INSTRUCTIONS
Symbols
• Thelabelonyourtoolmayincludethefollowingsymbols.Thesymbolsandtheir
definitionsareasfollows:
V .................. volts A ...................amperes
Hz ................ hertz W ..................watts
min ..............minutes
or AC .......alternating current
or DC ...direct current
n
o .................no load speed
................Class I Construction ..................earthing terminal
(grounded)
................safety alert symbol
................Class II Construction .../min or rpm...revolutions or
(double insulated) reciprocation per minute
............ Read instruction manual before use ..................Use proper respiratory protection
................Use proper eye protection ..................Use proper hearing protection
sfpm ........... surface feet per minute SPM .............. Strokes per minute
•
Whenusing anextension cord,be sureto useone heavyenough tocarry the
currentyourproductwilldraw.Anundersizedcordwillcauseadropinlinevoltageresulting
in loss of power and overheating. The table shows the correct size to use depending on cord
lengthandnameplateampererating.Ifindoubt,usethenextheaviergauge.Thesmallerthe
gauge number, the heavier the cord.
SAVE THESE INSTRUCTIONS
Minimum Gage for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50 51-100 101-150
  (0-7,6m)(7,6-15,2m)(15,2-30,4m)(30,4-45,7m)
240V 0-50 51-100 101-200 201-300
(0-15,2m)(15,2-30,4m)(30,4-60,9m)(60,9-91,4m)
Ampere Rating
More Notmore AmericanWireGage
Than Than
0 - 6 18 16 16 14
6 - 10 18 16 14 12
10 - 12 16 16 14 12
12 - 16 14 12 NotRecommended