INSTALLATION AND REMOVAL
OF THE BATTERY PACK
TO INSTALL BATTERY PACK: Insert
battery pack into the tool until an audible
Figure A). Make sure
battery pack is fully seated and fully
latched into position.
TO REMOVE BATTERY PACK: Depress
the battery release button as shown in figure
B and pull battery pack out of the tool.
A
B
FUNCTIONAL DESCRIPTION
Figure C
3. Shoe
4. Blade clamp release lever
3
1
2
4
5
C
7
8
9
6
Description Catalog #
These products use the batteries and chargers listed in the chart below.
20v Max* Lithium-Ion Batteries: PCC680L
PCC681L
PCC682L
PCC685L
20v Max* Lithium-Ion Battery Charger: PCC690L
PCC691L
PCC692L
PCC695L
OperAting instruCtiOns
WARNING: Always use proper eye
protection that conforms to ANSI
Z87.1(CAN/CSA Z94.3) while operating
this power tool.
NOTE
: Before cutting any type of
material, be sure it is firmly anchored or
clamped to prevent slipping.
to be cut.
maximum speed before starting the cut.
while cutting as shown in figure D.
be held firmly against the material being
cut. This will prevent the saw from
jumping or vibrating and will minimize
blade breakage.
D
TRIGGER SWITCH
feature to prevent unintentional operation.
Releasing the trigger turns the motor OFF.
NOTE: This tool has no provision to lock
the switch in the ON position, and should
never be locked in the ON position by any
other means.
BLADE CLAMP RELEASE LEVER
WARNING: Cut hazard. Turn off
and remove battery from tool before
making any adjustments or removing or
installing attachments or accessories.
WARNING: Cut hazard. Blade
breakage may occur if the blade does not
extend past the shoe and the workpiece
during the cut. Increased risk of personal
injury, as well as damage to the shoe and
workpiece may result.
TO INSTALL BLADE INTO SAW:
full open position as shown in figure E.
2. Insert blade shank from the front.
to make sure blade is clamped securely.
NOTE: BLADE CAN BE INSTALLED
UPSIDE-DOWN TO ASSIST IN FLUSH-
TO CUTTING.
To Next Page
Loading...
