How to make accurate cuts with Porter-Cable PCE980 Saw?
To improve cut accuracy with your Porter-Cable Saw: * Check that the edge guide is securely fastened to the fence, and adjust if necessary. * Ensure the cutting wheel is square to the fence; check and adjust as needed. * Verify the cutting wheel is perpendicular to the cart surface; adjust the fence if required. * Use the edge guide to prevent the workpiece from moving during cuts.
How to fix a Porter-Cable Saw that won't start?
If your Porter-Cable Saw isn't starting, here are a few things to check: * Ensure the cord is properly plugged into a working outlet. * Inspect the circuit fuse and replace it if blown. * Check the circuit breaker and reset it if it has tripped. * If the cord or switch appears damaged, have it replaced at an authorized PORTER-CABLE service center.
Why does my Porter-Cable PCE980 make unsatisfactory cuts?
If your Porter-Cable Saw is producing unsatisfactory cuts, consider the following: * A dull cutting wheel could be the culprit; replace it. * Ensure there's enough water in the tub; add water if needed. * Verify the cutting wheel isn't mounted backward; turn it around if it is. * Remove any build-up on the cutting wheel using a dressing stone. * Confirm you're using the correct cutting wheel for the material you're cutting; if not, change it.
What to do if my Porter-Cable Saw vibrates excessively?
If your Porter-Cable Saw is vibrating excessively, check these items: * Make sure the saw is placed on a level surface; reposition if necessary. * Inspect the cutting wheel for damage and replace it if needed.
Why cutting wheel on my Porter-Cable PCE980 Saw won't come up to speed?
If the cutting wheel on your Porter-Cable Saw isn't reaching full speed, the arbor might be loose. Try tightening it.
Explains safety alert symbols, words, and general warnings for safe operation.
Details proper grounding procedures and requirements for electrical safety.
Provides specific 'DO' and 'DON'T' instructions for operating the wet tile saw safely.
Instructions on how to operate the power switch and safety lock for starting and stopping.
Lists common issues, their potential causes, and recommended solutions for the wet tile saw.
General| Type | Circular Saw |
|---|---|
| Amperage | 15 Amps |
| Blade Diameter/Size | 7-1/4 inches |
| Weight | 9.5 lbs |
| Electric Brake | No |
| Spindle Lock | Yes |
| Dust Port | Yes |
| No Load Speed | 5500 rpm |
| Bevel Capacity | 55 degrees |
| Max Cutting Depth at 90° | 2-7/16 inches |
| Max Cutting Depth at 45° | 1-7/8 in |
To Next Page