shoe is firmly against the workpiece.
This will improve operator control and
minimize vibration.
These utilize a carbon steel back welded
to high speed steel teeth making the blade
more flexible and less prone to breaking.
MAINTENANCE
WARNING: REMOVE BATTERY
FROM SAW WHEN PERFORMING ANY
CLEANING OR OTHER MAINTENANCE.
WHEN SERVICING USE ONLY
IDENTICAL REPLACEMENT PARTS.
parts. Most plastics are susceptible to
various types of commercial solvents and
may be damaged by their use. Use only
mild soap and damp cloth to clean the tool.
immerse any part of the tool into a liquid.
fiberglass boats, sports cars, drywall
etc.,they are subject to accelerated wear
and possible premature failure, as the
fiberglass chips and grindings and drywall
dust are highly abrasive to bearings,
brushes, commutator, etc. During any
use on fiberglass or drywall it is extremely
important that the tool be cleaned
frequently by blowing with an air jet.
LUBRICATION
Your tool was properly lubricated before
leaving the factory. Once every year take
or send your tool to a
service
center, or authorized service station,
for a complete cleaning, inspection and
lubrication. Tools “out of service” for long
periods should be relubricated before
being put back to work.
ACCESSORIES
Your reciprocating saw will accept up to a
blade suitable for your project. Longer blades
are more likely to be bent or damaged during
use. During operation, some longer blades
may vibrate or shake if the saw is not kept in
contact with the workpiece.
WARNING: Since accessories,
product, use of such accessories with this
tool could be hazardous. To reduce the
recommended accessories should be used
with this product.
A complete line of accessories is available
or for the name of your nearest supplier.
THE RBRC™ SEAL
already been paid by . In some
batteries in the trash or municipal solid waste
environmentally conscious alternative.
and other battery users, has established
batteries. Help protect our environment and
conserve natural resources by returning the
tool to an authorized
service
center for recycling. You may also contact
your local recycling center for information on
where to drop off the spent battery, or call
1-800-8-BATTERY.
Operation is subject to the following two
must accept any interference received,
including interference that may cause
undesired operation.
NOTE:
This equipment has been tested and
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
equipment and the receiver.
a circuit different from that to which the
receiver is connected.
not expressly approved by the party
responsible for compliance could void the
user’s authority to operate the equipment.
To Next Page
Loading...
