8
EMPTING THE TANK
BLOWING OPERATION
WARNING
To reduce the risk of injury from accidental starting, unplug power cord before emptying
the dust tank.
1. Remove the power head assembly of the wet/dry vacuum by pulling outward on the lid
clips located on each side of the vacuum. Lift off the power head assembly.
2. Dump the tank contents into the proper waste disposal container.
The vacuum contains a blowing feature. Follow the steps below to use the vacuum
as a blower.
1. Locate blowing port on the vacuum.
2. Insert one end of the 1-1/4 in. x 7 ft. hose into the blower port.
3. Turn the vacuum "ON".
WARNING
Always wear safety eyewear complying with ANSI Z87.1 (or in Canada CSA Z94.3)
when using as a blower.
WARNING
To avoid injury to bystanders, keep them clear of blowing debris.
CAUTION
Wear a dust mask if blower creates dust which might be inhaled.
CAUTION
To reduce the risk of hearing damage, wear ear protection when using the vac/blower
for extended hours or in confined space.
To Next Page
Loading...
