XSTREAM USER MANUAL
MOUNTING THE HOSE
First time mounting the hose of the length
you have chosen, start with unscrewing
the blind-screw (5mm allen-key) where
you want the 2nd stage. Be careful not to
contamine either the open port or the
hose end. Screw the hose in place using a
13mm box spanner. Continue with
attaching the 2nd stage. Just screw the
nut over the 2nd stage housing, and
secure it rmly by hand.
General safety regulations
OXYGEN ALERT!
If you have an Oxygen, Deco or Duration model, be absolutely
sure not to touch the o-ring or other inner connection areas with
your ngers, since grease from your ngers are a combustible
contamination.
PRE DIVE
The procedure described below only
describes the manner in which the
regulator is assembled, and does not
replace all of the various procedures you
have learned in your diving training program.
Xstream must always be used with
minimum the following SCUBA equipment:
• Compressed gas cylinder(s)
conforming to national regulations.
• Frame or holding device for the
cylinder(s) with the possibility to
mount the harness.
16
To Next Page
Loading...
