POSline SM2450 - User Manual

Enter/Exit Programming Mode
Scan this barcode to enter the set-up and exit after set-up finished.
Display firmware version
Reading of the “Display Firmware Version” will
show the current firmware version on host.
Return to PC/AT default
This barcode allows setting in keyboard wedge
interface for IBM PC AT/PS/2 and compatibles.
Return to RS-232 default
The RS-232C interface scanner is often used
when connecting to the serial port of a PC or
terminal, reading the barcode to set the scanner
into RS-232 interface.
Return to USB default
Reading of “Return to USB default” sets the
device into USB interface support.
** For more set-up selections, please refer to Programming Guide in the CD-ROM in the package.**
Important Notice
No warranty of any kind is made in regard to this material, including, but not limited to, implied warranties of merchantability or fitness for a
particular purpose. We are not liable for any errors contained herein or incidental or consequential damages in connection with furnishing,
performance or use of this material.
Copyright © 2009. All rights reserved.
Laser Safety
The laser scanner complies with safety standard IEC 60825-1 for a Class I laser produce. It also complies with CDRH as applicable to a Class IIa
laser product. Avoid long term staring into direct laser light.
CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous
radiation exposure.
SM2450
QUICK GUIDE

Summary

Scanner Programming via Barcodes

Enter;Exit Programming Mode

Scan barcode to enter programming mode and exit after set-up is finished.

Display Firmware Version

Read barcode to show the current firmware version on host.

Reset Interface Defaults

Scan barcodes to set scanner to PC/AT, RS-232, or USB default interface.

Safety and Legal Notices

Laser Safety Information

Scanner complies with Class I laser standards; avoid staring into direct laser light.

General Disclaimer

No warranty is made regarding material, including merchantability or fitness for purpose.

Device Handling and Connectivity

Adjusting Scan Angle

Use the hinge shaft to tilt the device forward/backward for optimal scan angle.

Aiming and Decoding

Press trigger for scan line; press again to decode barcode. One beep indicates a good read.

Interface Support

Device supports Keyboard wedge, RS-232, and HID USB interfaces. Connect cable properly.

Installation Methods

Mounting with Suction Cup

Attach cupulate stand to smooth surface. Clean surface, press device, and secure with lever.

Mounting with Screws

Device has 3 mounting holes for permanent fixture. Refer to figure for dimensions.

POSline SM2450 Specifications

General

Interface	USB
Scanning Technology	Laser
Scan Rate	100 scans per second
Operating Voltage	5 VDC
Operating Current	100 mA
Type	Handheld Barcode Scanner
Supported Barcodes	Code 39, Code 128, Interleaved 2 of 5, Codabar