Potensic D88 - Battery installation

Install the battery of remote controller
Prepare the Remote Controller
!
● Insert batteries with correct polarity.
● Do not mix up the old batteries with the new ones.
● Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium)
batteries.
● Ensure the rechargeable batteries have been removed from the aircraft before
being charged.
● Rechargeable batteries are only to be charged under adult supervision.
● Exhausted batteries must be removed from the aircraft.
Step 1: Unfold the hand sticks and open the battery cover (Pic. 1);
Step 2: Install two*AA batteries into the battery compartment according to the given polarity (Pic. 2);
Step 3: Close the battery compartment (Pic. 3).
Pic. 1 Pic. 2 Pic. 3
Potenstic D88 User Manual
Battery installation
!
Slide the battery into the battery compartment at the rear of the aircraft by pushing with appropriate
force. Make sure that you hear a click sound indicating the battery is firmly installed.
Attention: The battery should be installed firmly, failure to do so may affect the flight
safety of your aircraft. The aircraft may crash due to power-disconnecting
during the flight.
-2-