Potensic D88 - Aircraft Operations; Signal connection between the aircraft and remote controller; Aircraft initialization detection

!
Attention: Make sure that the aircraft is set on a flat and still surface for the
initialization detection.
Aircraft initialization detection
After signal connection, the aircraft enters into initialization detection procedure with front and rear
lights flashing red, green and yellow alternatively. Make sure that the aircraft is set on a flat and still
surface for the initialization detection. The aircraft initialization detection takes about 8 seconds.
Once the remote controller sends out “Di Di” sounds and the aircraft front and rear lights flash yellow
alternatively, initialization detection is completed.
!
● Signal connection is done once for all if the remote controller is not linked to other
aircraft.
● Set the connection one by one to avoid signal connection error.
● Turn on the aircraft (Pic. 2). The aircraft will make beep sounds with front and rear lights flashing
and will automatically link to the remote controller. Once the remote controller sends out a long beep
sound and the indicator light of the remote controller turns from flashing to solid on and the signal
icon “ ” is shown on the LCD screen,it means that the signal is connected successfully.
Pic. 1 Pic. 2
Signal connection between the aircraft and remote controller
● Keep pressing the red button “ ” and turn on the remote controller (Pic. 1). The remote controller
makes 2 beep sounds, and the indicator light “ ” keeps flashing; the remote controller is under
signal connection status.
Aircraft Operations
Potenstic D88 User Manual
-24-