What to do if the water pressure is too low in my Potterton eurocondense four 125 kw?
If the water pressure of your Potterton Boiler is too low, you should check the water pressure and top it up with water if necessary.
Why won't the burner start on my Potterton eurocondense four 125 kw?
If the burner of your Potterton Boiler does not start, you should check for several things: * No voltage at the control and regulating center * No 'burner ON' signal from the heating circuit control * Gas tap closed * No ignition
What to do if the water pressure is too high in my Potterton eurocondense four 125 kw Boiler?
If the water pressure of your Potterton Boiler is too high, check the water pressure and drain water if necessary.
What to do if there is no flame during the safety time in my Potterton eurocondense four 125 kw Boiler?
If there is no flame during the safety time in your Potterton Boiler, you can try to reset it. If the fault re-occurs several times, contact an installer. Also, check for: * Lack of gas * Polarity of mains connection * Safety period * Ignition electrode and ionization current
What causes the burner to go into fault mode without flame formation in my Potterton eurocondense four 125 kw Boiler?
If the burner goes into fault mode without flame formation in your Potterton Boiler, check for: * No ignition * If the ionization electrode has a ground connection * If the ionization electrode is not connected * No gas * If the gas pressure is too low
What to do if there is a DHW temperature 1 sensor fault in my Potterton Boiler?
If there is a DHW temperature 1 sensor fault in your Potterton Boiler, check the connection and inform a heating specialist. Emergency operation is also an option.
How to fix an outside temp sensor fault on a Potterton eurocondense four 125 kw Boiler?
If there is an outside temp sensor fault in your Potterton Boiler, check the connection or the outside temp sensor. Emergency operation is also an option.
What should I do if my Potterton eurocondense four 125 kw displays a Flow temperature 2 sensor fault?
If there is a Flow temperature 2 sensor fault in your Potterton Boiler, check the connection and inform a heating specialist.
What to do if there is a DHW temperature 2 sensor fault in my Potterton eurocondense four 125 kw?
If there is a DHW temperature 2 sensor fault in your Potterton Boiler, check the connection and inform a heating specialist.
Why does my Potterton eurocondense four 125 kw Boiler burner go into fault mode even when a flame is present?
If the burner goes into fault mode in spite of flame formation in your Potterton Boiler, check if: * The ionization electrode is defective or soiled * The ionization electrode does not penetrate the flame * The ionization electrode is not connected * The gas pressure is not stable
General| Boiler Type | Condensing |
|---|---|
| Max. Output (kW) | 125 kW |
| Output | 125 kW |
| Fuel | Natural Gas |
| Modulation | 1:5 |
| Warranty | 2 years |
To Next Page
