Need help?Do you have a question about the Potterton Suprima 50 and is the answer not in the manual?
General| Model | Suprima 50 |
|---|---|
| Manufacturer | Potterton |
| Category | Boiler |
| Fuel Type | Gas |
| Efficiency Rating | 78% |
| Type | Conventional |
| Boiler Type | Heat Only |
| Mounting | Wall Mounted |
| Max Operating Pressure | 3 Bar |
| Central Heating Flow Temperature Range | 82°C |
Introduction to Suprima System Boilers with Mid Position Valve Kit Option.
Identification of boiler packs, sealed system modules, and optional kits.
Components included in Boiler Mounting Frame kits, standard and MPV versions.
Contents of the Optional Mid Position Valve Kit (MPV).
Detailed list of components for the Sealed System Module.
Steps for installing the boiler mounting frame on the wall.
Instructions for making bottom and top pipework connections to the frame.
Illustrates the system pipework connecting through the top of the mounting frame.
Procedure for fitting the vessel/pump carrier assembly to the mounting frame.
Instructions for installing the flow pipe extension for standard systems.
Steps for installing the Optional Mid Position Valve Kit.
Guidance on routing pipes and connecting the gas pipe to the frame.
Steps to prepare the boiler and mount it onto the frame.
Connecting flow, return pipes, and gas pipe to the boiler.
Details on pressure relief valve, discharge pipe, and system venting.
Procedures for commissioning the system and wiring its components.
Detailed wiring diagram for electronic controls, programmers, and thermostats.
Detailed wiring diagram for mechanical controls, programmers, and thermostats.
Wiring diagram for Suprima Boiler with typical third-party controls.
Steps to safely isolate the boiler and drain the system for replacement.
Method for replacing the Mid Position Valve motor without draining the system.
Notes on accessing and replacing isolating valves, which requires system draining.
Procedure for replacing the expansion vessel and its flexible hose.
Instructions for replacing automatic and manual bleed valves.
Steps for refilling and venting the system after component replacement.
Illustrated list of spare parts with their descriptions and makers' part numbers.
To Next Page