Poulan Pro PB195A42LT Repair Parts Manual

Poulan Pro PB195A42LT

20 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

REPAIR PART'S MANUAL

MODEL:

PB195A42LT

LAWN TRACTOR

ALWAYS WEAR EYE PROTECTION DURING OPERATION

Visit our website: www.poulan-pro.com

WARNING:

Read this Man u al and follow all Warnings

and Safety Instructions. Fail ure to do so can

re sult in serious in ju ry.

IMPORTANT MANUAL Do Not Throw Away

532 43 88-83 10.25.10 BAD Printed in U.S.A.

Table of Contents

Other manuals for Poulan Pro PB195A42LT

Operator's Manual28 pages

Questions and Answers:

M
Marvin DavisAug 20, 2025
How to fix a Poulan Pro PB195A42LT that will not start?
- C
  Chelsea LopezAug 20, 2025
  If your Poulan Pro Lawn Mower won't start, several factors could be at play. It might be out of fuel, so begin by filling the fuel tank. Ensure the engine is choked properly as described in the Operation section. If the engine is flooded, wait a few minutes before trying again. Other potential issues include a bad spark plug (replace it), a dirty air filter (clean or replace it), or a dirty fuel filter (replace it). Water in the fuel can also be a culprit; in this case, empty the fuel tank and carburetor, refill with fresh gasoline, and replace the fuel filter. Check all wiring for looseness or damage. If the carburetor is out of adjustment, consult the Service Adjustments section for how to adjust it. For engine valve adjustments, it's best to contact an authorized service center.
Y
yorkjenniferAug 22, 2025
How to troubleshoot a Poulan Pro PB195A42LT that is hard to start?
- M
  melissabooneAug 22, 2025
  If your Poulan Pro Lawn Mower is hard to start, begin by checking the air filter and clean or replace it if it's dirty. Replace the spark plug if it's bad. Recharge or replace the battery if it's weak or dead. Replace the fuel filter if it's dirty. If the fuel is stale or dirty, empty the fuel tank and refill it with fresh, clean gas. Also, check all wiring for any looseness or damage. If the carburetor is out of adjustment, see the Service Adjustments section for instructions. For engine valve adjustments, it's recommended to contact an authorized service center.
R
Richard WilliamsAug 25, 2025
Why Poulan Pro PB195A42LT blades will not rotate?
- A
  Alexander RamosAug 25, 2025
  If your Poulan Pro Lawn Mower blades will not rotate, check for any obstruction in the clutch mechanism and remove it. If the mower drive belt is worn or damaged, replace it. If the idler pulley is frozen, replace it. Also, if the blade mandrel is frozen, replace it.
M
Michael OlsonAug 26, 2025
What causes a Poulan Pro Lawn Mower engine to click but not start?
- J
  jessica91Aug 26, 2025
  If your Poulan Pro Lawn Mower engine clicks but will not start, the battery might be weak or dead, so recharge or replace it. Corroded battery terminals can also be a cause, so clean them. Check all wiring for looseness or damage. A faulty solenoid or starter could also be the problem, so check and replace them if necessary.
M
Michael PetersonAug 30, 2025
What to do if Poulan Pro Lawn Mower engine will not turn over?
- H
  Heather DayAug 30, 2025
  If the Poulan Pro Lawn Mower engine will not turn over, make sure that you depress the brake pedal. Disengage the attachment clutch. If the battery is weak or dead, recharge or replace it. Replace the fuse if it's blown. Clean the battery terminals if they are corroded. Check all wiring for looseness or damage. Check or replace the ignition switch if it's faulty. Check or replace the solenoid or starter if they are faulty. If the operator presence switch(es) are faulty, contact an authorized service center.
A
Austin RodriguezSep 1, 2025
How to fix a Poulan Pro PB195A42LT Lawn Mower with poor uneven cut?
- B
  Brian DennisSep 1, 2025
  If your Poulan Pro Lawn Mower produces a poor, uneven cut, the blade might be worn, bent, or loose; replace the blade and tighten the blade bolt. Ensure the mower deck is level. Clean any buildup of grass, leaves, or trash under the mower. If the blade mandrel is bent, replace it. Also, clean around the mandrels to open vent holes if they are clogged with grass, leaves, and trash.
M
Matthew RodriguezSep 3, 2025
Why is my Poulan Pro PB195A42LT experiencing excessive vibration?
- K
  Krystal HallSep 3, 2025
  If your Poulan Pro Lawn Mower exhibits excessive vibration, it could be due to a worn, bent, or loose blade, in which case you should replace the blade and tighten the blade bolt. A bent blade mandrel could also be the cause, so replace it if necessary. Additionally, check for any loose or damaged parts, tightening the loose ones and replacing the damaged ones.
D
derrickperezSep 5, 2025
What causes poor grass discharge from a Poulan Pro PB195A42LT Lawn Mower?
- A
  Alisha CareySep 5, 2025
  If your Poulan Pro Lawn Mower has poor grass discharge, ensure the engine speed is not too slow by placing the throttle control in the “FAST” position. If your travel speed is too fast, shift to a slower speed. Wet grass can also cause this issue, so allow the grass to dry before mowing. Make sure the mower deck is level and check the tires for proper air pressure. Replace the blade and tighten the blade bolt if it is worn, bent, or loose. Clean any buildup of grass, leaves, or trash under the mower. If the mower drive belt is worn, replace it. Ensure the blades are installed with the sharp edge down and replace with the blades listed in the parts manual if improper blades are used. Clean around mandrels to open vent holes if they are clogged.
T
timothyandersonSep 7, 2025
Why are the headlights not working on my Poulan Pro PB195A42LT?
- T
  Terri VaughnSep 7, 2025
  If the headlight(s) on your Poulan Pro Lawn Mower are not working, first ensure the switch is turned “ON”. If that's not the issue, the bulb(s) or lamp(s) may be burned out, so replace them. A faulty light switch could also be the problem, so check and replace it if necessary. Check the wiring and connections for any looseness or damage. Finally, check if the fuse is blown and replace it if needed.
J
Juan KellySep 9, 2025
Why Poulan Pro PB195A42LT battery will not charge?
- D
  Danielle LutzSep 9, 2025
  If the battery on your Poulan Pro Lawn Mower will not charge, it could be due to bad battery cell(s), in which case you should replace the battery. Check and clean all connections to ensure they are not causing poor cable connections. If your equipment has a regulator, a faulty one could be the problem, so replace the regulator. Finally, a faulty alternator could also be the cause, so replace the alternator if necessary.

Poulan Pro PB195A42LT Specifications

General

Transmission	Automatic
Deck Material	Steel
Warranty	2 years
Engine Type	Gasoline
Cutting Width	42 inches
Height Adjustment	6-position
Fuel Tank Capacity	1.5 gal
Cutting Height	1.5 to 4 inches
Engine	Briggs & Stratton

Related product manuals

Poulan Pro PB195A46LT

Preview: Poulan Pro PB19546LT

Poulan Pro PB19546LT

Poulan Pro PB19542LT

Preview: Poulan Pro PB195H42LT

Poulan Pro PB195H42LT

Poulan Pro PB195H46YT

Preview: Poulan Pro Pro PB195H42LT

Poulan Pro Pro PB195H42LT

Poulan Pro PB19H42YT

Preview: Poulan Pro PB155G42

Poulan Pro PB155G42

Preview: Poulan Pro PB185A42

Poulan Pro PB185A42

Preview: Poulan Pro PB14538LT

Poulan Pro PB14538LT

Poulan Pro PB175A42LT