Poulan Pro PB195H42LT

Questions and Answers

G
gonzalezheatherAug 25, 2025
How to fix Poulan Pro PB195H42LT Lawn Mower that is hard to start?
- M
  Matthew GrahamAug 25, 2025
  If your Poulan Pro Lawn Mower is hard to start, consider the following: * A dirty air filter. Clean or replace it. * A bad spark plug. Replace it. * A weak or dead battery. Recharge or replace the battery. * A dirty fuel filter. Replace the fuel filter. * Stale or dirty fuel. Empty the fuel tank and refill it with fresh, clean gas. * Loose or damaged wiring. Check all wiring. If these steps don't work, the carburetor might be out of adjustment (see 'To Adjust Carburetor' in Service Adjustments), or the engine valves might need adjustment, so contact an authorized service center/department.
E
eriklunaAug 26, 2025
What to do if Poulan Pro Lawn Mower engine will not turn over?
- T
  tiffanycastilloAug 26, 2025
  If the engine of your Poulan Pro Lawn Mower will not turn over, make sure that the brake pedal is depressed. Also, disengage the attachment clutch. Check the battery; recharge or replace it if it's weak or dead. Replace the fuse if it's blown. Clean the battery terminals if they are corroded. Inspect all wiring for looseness or damage. If the problem persists, check or replace the ignition switch, solenoid, or starter. For faulty operator presence switches, contact an authorized service center/department.
M
micheletuckerAug 30, 2025
What to do if Poulan Pro Lawn Mower engine clicks but will not start?
- S
  Samantha MartinezAug 30, 2025
  If your Poulan Pro Lawn Mower engine clicks but doesn't start, the issue might stem from a weak or dead battery; recharge or replace it. Corroded battery terminals could also be the culprit; clean them thoroughly. Check for any loose or damaged wiring and ensure it's properly connected. If these steps don't resolve the problem, there might be a faulty solenoid or starter, which would need to be checked or replaced.
M
Malik NavarroSep 1, 2025
Why Poulan Pro PB195H42LT Lawn Mower has poor cut that is uneven?
- S
  shelby03Sep 1, 2025
  An uneven cut with your Poulan Pro Lawn Mower can result from a worn, bent, or loose blade. Replace the blade and tighten the blade bolt. Ensure the mower deck is level. Buildup of grass, leaves, or trash under the mower can also cause this issue, so clean the underside of the mower housing. Additionally, a bent blade mandrel should be replaced, and clogged mower deck vent holes should be cleaned to remove any buildup of grass, leaves, and trash around the mandrels.
J
Jimmy WilliamsSep 3, 2025
Why Poulan Pro PB195H42LT Lawn Mower blades will not rotate?
- Y
  Yolanda AndersonSep 3, 2025
  If the mower blades of your Poulan Pro Lawn Mower won't rotate, there might be an obstruction in the clutch mechanism; remove any obstruction. The mower drive belt could be worn or damaged, requiring replacement. A frozen idler pulley or blade mandrel could also be the cause, and these would need to be replaced.
H
Howard PerrySep 5, 2025
What causes excessive vibration in Poulan Pro Lawn Mower?
- M
  Mark ColonSep 5, 2025
  Excessive vibration in your Poulan Pro Lawn Mower can be attributed to a worn, bent, or loose blade. Replace the blade and tighten the blade bolt. Another cause could be a bent blade mandrel, which would need replacement. Also, check for any loose or damaged parts and tighten or replace them as necessary.
A
Andrea RyanSep 7, 2025
Why Poulan Pro Lawn Mower headlight(s) not working?
- M
  Mallory MooreSep 7, 2025
  If the headlight(s) on your Poulan Pro Lawn Mower are not working, first ensure the switch is turned 'ON'. If that's not the issue, the bulb(s) or lamp(s) may be burned out and need replacement. Check the light switch for faults and replace if necessary. Inspect the wiring and connections for any looseness or damage. Lastly, check and replace the fuse if it's blown.
C
Christopher ChaseSep 9, 2025
Why Poulan Pro Lawn Mower battery will not charge?
- O
  owrightSep 10, 2025
  If the battery of your Poulan Pro Lawn Mower will not charge, it could be due to bad battery cell(s), in which case the battery should be replaced. Check and clean all cable connections to ensure they are not causing a poor connection. If your mower is equipped with a regulator, a faulty regulator could be the issue and would need to be replaced. Alternatively, a faulty alternator could also prevent the battery from charging, requiring its replacement.
J
Joshua MartinezSep 12, 2025
What causes loss of drive in Poulan Pro Lawn Mower?
- K
  Kelly ThompsonSep 12, 2025
  A loss of drive in your Poulan Pro Lawn Mower can occur if the freewheel control is in the “disengaged” position; place it in the “engaged” position. A worn, damaged, or broken motion drive belt will also cause this issue, so replace the motion drive belt. Air trapped in the transmission during shipment or servicing can also lead to a loss of drive; in this case, purge the transmission. Finally, check for a missing axle key and install one at the rear wheel if necessary.
M
Mario SnyderSep 14, 2025
Why Poulan Pro Lawn Mower engine "back- fires” when turning engine “OFF”?
- L
  Lisa BoltonSep 14, 2025
  If your Poulan Pro Lawn Mower engine "back-fires” when turning it “OFF”, ensure that the engine throttle control is set between half and full speed (fast) position before stopping the engine.