Computed kickback angle (CKA
BAR
MODEL PiN Length
PPB3416 952044366 16"
PPB4218 952044686 18"
Table
CHAIN P/N
952051211
952051338
CKA without chain brake
33
33"
NOTE: If this saw is to be used for com-
mercial logging, a chain brake is required
and shaII not be removed or otherwise dis-
ab}ed to compIy with Federal OSHA Regula-
tions for Commercial Logging.
Ai_WARNING: The engine exhaust
from this product contains chemicais known
to the State of California to cause cancer,
birth defects or other reproductive harm.
SAFETY NOTICE: Exposure to vibrations
through prolonged use of gasoline powered
hand tools could cause blood vesset or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or
abnormal swellings. Prolonged use in cold
weather has been linked to blood vessel
damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength, change in skin color or texture,
or loss of feeling in the fingers, hands, or joints,
discontinue the use of th_s tool and seek
med_ca_ attention. An anti-vibration system
does not guarantee the avoidance of these
problems. Users who operate power toots on
a continual and regular basis must monitor
closely their physical cood_ion and the
cond_on of this tool
SPECIAL NOTtC E: Your saw is equipped
with a temperature limiting muffler and spark
arresting screen which meets the
requirements of California Codes 4442 and
4443. All US. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
law that many internal combustion engines
to be equipped with a spark arresting screen.
if you operate a chain saw in a state or Iocaie
where such regulations exist, you are legally
responsible for maintaining the operating
condition of these parts. Faiiure to do so is
a violation of the law. Refer to the SERVICE
section for maintenance of the spark
arresting screen.
Failure to follow all Safety Rules and Precau-
tions can result inserious injury. If situations
occur which are not covered in this manual,
use care and good judgement. If you need
assistance, contact your authorized service
dealer or caII t -800-554-6723.
STANDARDS: This saw is Iisted by Under-
writer's Laboratories, Inc., in accordance w_th:
ANSI B175.1-2000 American National
Standards for Gasoline-Powered Chain
Saws - Safety Requirements
CSA Z62.1-03 Chain Saws - Occupational
Health and Safety
CSA Z62.3-66 Chain Saw Kickback Occu-
pationaI Heatth and Safety
Protective g}oves (not provided) should be
worn during assembly.
ATTACHING THE BAR & CHAIN (If not
a_ready attached)
_kWARNING: If received assembled,
repeat all steps to ensure your saw isproperly
assembled and all fasteners are secure Al-
ways wear gloves when handling the chain.
The chafn is sharp and can cut you even when
it is not moving!
1. Loosen and remove the bar nuts and the
clutch cover from the saw.
2. Remove the plastic shipping spacer (if
present).
Clutch cover
Bar nuts Location of
'_, shipping
spacer
Chain adjustment tool
(Bar Too0
To Next Page
Loading...
