Poulan Pro PR28PS - Lubricating Guide Bar & Chain; Guide Bar Maintenance; Accessories; Approved and Optional Accessories

8. Get a rounded front corner of the depth gauge with
the flat file. Make sure that the top of the depth
gauge is level.
To lubricate the guide bar and the chain
WARNING: Do not use waste oil. To use
waste oil can be dangerous to you and can
cause damage to the product and
enviroment.
The chain oil supplies continuous lubrication to the chain
and the guide bar. The oil output is automatically
monitored to make sure that there is sufficient oil. If
there is no sufficient oil, it will cause damage to the
guide bar and the chain, and too much heat. Too much
heat causes smokes in the chain and/or can change the
color of the guide bar. Always fill the bar oil tank when
you fill the fuel tank.
Obey these instructions to lubricate the guide bar and
the chain:
1. Stop the engine.
2. Remove the oil cap.
3. Fill the bar oil tank.
To do the maintenance on the guide bar
WARNING: Do the maintenance on the
guide bar when:
• The product cuts to one side.
• You must push the product through with
force.
• The lubrication of the guide bar is not
sufficient.
After each operation, clean all sawdust from
the guide bar and the sprocket hole.
WARNING: Replace the guide bar when:
• The groove is worn.
• The guide bar bends or has cracks.
• The guide bar rails get too much heat
when you cut.
• Burrs occur to the guide bar rails.
It causes damage to the chain and becomes
not easy when you cut if the guide bar is
worn.
1. Disconnect the spark plug.
2. Loosen the clamp nut and remove the chain brake.
3. Remove the guide bar and the chain.
4. Clean the oil holes and the groove.
Note: It is necessary to clean the oil holes and the
groove after each 5 hours operation.
5. Remove the burrs of the guide bar rails with a flat
file.
Note: Burrs of the guide bar rails are a usual
process when the guide bar rail wears.
6. Use a flat file to restore smooth edges and sides if
the top of the guide bar rail is rough.
7. Replace the guide bar.
ACCESSORIES
PR28PS
Approved accessories Type Cutting attachment guard
Thread shaft (5/16 R)
Trimmer head P25 585345904
Optional accessories Type Use with
Edger attachment with shaft PP1000E PR28PS
Cultivator attachment with shaft PP2000D PR28PS
Blower attachement with shaft PP3000B PR28PS
Brushcutter attachment with shaft PP4000C PR28PS
Saw attachment with shaft PP5500P PR28PS
226 - 004 - 17.10.2018 19