Poulan Pro PRO PB22H46YT Repair Parts Manual

Poulan Pro PRO PB22H46YT

18 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

REPAIR PARTS MANUAL

MODEL:

PB22H46YT

LAWN TRACTOR

ALWAYS WEAR EYE PROTECTION DURING OPERATION

Visit our website: www.poulan-pro.com

WARNING:

Read this Man u al and follow all Warnings

and Safety Instructions. Fail ure to do so

can re sult in serious in ju ry.

IMPORTANT MANUAL DO NOT THROW AWAY

431617 10.13.09 SR Printed in the U.S.A.

03032

Table of Contents

Other manuals for Poulan Pro PRO PB22H46YT

Operator's Manual28 pages

Questions and Answers:

D
Denise MeyerAug 19, 2025
Why Poulan Pro Lawn Mower will not start?
- S
  Sherry MurphyAug 19, 2025
  Your Poulan Pro Lawn Mower might not start due to several reasons. It could be out of fuel, so fill the fuel tank. The engine may not be choked properly; refer to the “TO START ENGINE” section in your manual. The engine might be flooded, so wait a few minutes before trying again. Other potential causes include a bad spark plug (replace it), a dirty air filter (clean or replace it), a dirty fuel filter (replace it), water in the fuel (empty the tank and carburetor, refill with fresh gasoline, and replace the fuel filter), loose or damaged wiring (check all wiring). In some cases, the carburetor may need adjustment (see “To Adjust Carburetor” in the Service Adjustments section), or the engine valves might be out of adjustment.
T
Tracy HollowayAug 21, 2025
Why Poulan Pro Lawn Mower engine will not turn over?
- T
  thomasdawnAug 22, 2025
  If the engine of your Poulan Pro Lawn Mower won't turn over, make sure that the brake pedal is depressed. Also, ensure that the attachment clutch is disengaged. A weak or dead battery can also be the cause, so recharge or replace the battery. Check for a blown fuse and replace it if necessary. Clean any corroded battery terminals. Inspect all wiring for looseness or damage. A faulty ignition switch may also be the culprit, so check or replace it. Lastly, examine the solenoid or starter for faults and replace them if needed.
D
diazhannahAug 26, 2025
How to fix hard to start Poulan Pro PRO PB22H46YT?
- S
  Shane Walker Jr.Aug 26, 2025
  If your Poulan Pro Lawn Mower is hard to start, consider these possible causes. A dirty air filter can cause this issue, so clean or replace it. A bad spark plug could also be the problem, so replace it. If the battery is weak or dead, recharge or replace it. A dirty fuel filter can also make it hard to start, so replace it. Stale or dirty fuel could be the culprit; empty the fuel tank and refill it with fresh, clean gas. Check all wiring for looseness or damage. In some cases, the carburetor may need adjustment (see “To Adjust Carburetor” in Service Adjustments).
K
Kimberly AlvarezAug 28, 2025
What causes Poulan Pro Lawn Mower blades will not rotate?
- C
  Charles AdamsAug 28, 2025
  If the blades on your Poulan Pro Lawn Mower won't rotate, there are several potential causes. There might be an obstruction in the clutch mechanism, so remove it. The mower drive belt could be worn or damaged, so replace it. A frozen idler pulley could also be the issue, so replace the idler pulley. Lastly, a frozen blade mandrel could be the cause, so replace the blade mandrel.
W
webbkimAug 30, 2025
What to do if Poulan Pro Lawn Mower battery will not charge?
- B
  Brittany MooreAug 30, 2025
  If your Poulan Pro Lawn Mower battery will not charge, consider these potential reasons. The battery cell(s) might be bad, so replace the battery. Poor cable connections can also prevent charging, so check and clean all connections. If your mower is equipped with a regulator, it might be faulty, so replace the regulator. A faulty alternator can also cause charging problems, so replace the alternator.
J
Juan GreenSep 1, 2025
What to do if Poulan Pro PRO PB22H46YT has poor grass discharge?
- G
  Gail DelacruzSep 1, 2025
  If you're experiencing poor grass discharge with your Poulan Pro Lawn Mower, several factors could be the cause. Ensure the engine speed isn't too slow by placing the throttle control in the “FAST” position. Avoid traveling too fast by shifting to a slower speed. Wet grass can also hinder discharge, so allow the grass to dry before mowing. Make sure the mower deck is level. Check the tires for proper air pressure. Replace the blade if it is worn, bent or loose, and tighten the blade bolt. Clear any buildup of grass, leaves, or trash under the mower. Replace the mower drive belt if it's worn. Ensure blades are installed with the sharp edge down. Replace with blades listed in parts manual if improper blades are used. Clean around mandrels to open vent holes if clogged.
K
Kim ThomasSep 3, 2025
Why Poulan Pro Lawn Mower engine clicks but will not start?
- R
  Richard HudsonSep 3, 2025
  If your Poulan Pro Lawn Mower engine clicks but doesn't start, it could be due to a weak or dead battery; try recharging or replacing it. Corroded battery terminals can also cause this, so clean them. Check for loose or damaged wiring. A faulty solenoid or starter might also be the problem, so check or replace those components.
R
richard80Sep 6, 2025
How to resolve excessive vibration in Poulan Pro Lawn Mower?
- H
  hebertmasonSep 6, 2025
  To address excessive vibration in your Poulan Pro Lawn Mower, start by checking the blade. If it's worn, bent, or loose, replace the blade and tighten the blade bolt. Also, inspect the blade mandrel; if it's bent, replace it. Finally, look for any loose or damaged parts, tighten any loose parts, and replace any damaged parts.
C
Christopher GutierrezSep 7, 2025
What causes poor cut and uneven Poulan Pro Lawn Mower?
- W
  william86Sep 8, 2025
  If your Poulan Pro Lawn Mower is producing a poor and uneven cut, several factors could be responsible. A worn, bent, or loose blade can cause this, so replace the blade and tighten the blade bolt. Ensure that the mower deck is level. Buildup of grass, leaves, or trash under the mower can also affect the cut, so clean the underside of the mower housing. A bent blade mandrel can also lead to an uneven cut, so replace the blade mandrel. Lastly, check for clogged mower deck vent holes and clean around mandrels to open vent holes.
T
Tracy MckeeSep 10, 2025
How to fix Poulan Pro PRO PB22H46YT Lawn Mower headlight(s) not working?
- T
  tamaraparkerSep 10, 2025
  If the headlight(s) on your Poulan Pro Lawn Mower are not working, first ensure that the switch is turned “ON”. If that doesn't solve the problem, the bulb(s) or lamp(s) may be burned out, so replace them. A faulty light switch could also be the issue, so check or replace it. Inspect the wiring and connections for looseness or damage. Finally, check for a blown fuse and replace it if necessary.

Poulan Pro PRO PB22H46YT Specifications

General

Engine	Briggs & Stratton
Engine Displacement	724 cc
Cutting Height	1.5-4 inches
Cutting Height Positions	6
Transmission Type	Hydrostatic
Fuel Capacity	1.5 gallons
Blade Engagement	Electric
Deck Material	Steel
Number of Blades	2
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Cutting Width	46 inches
Front Tire Size	15 x 6 inches
Rear Tire Size	20 x 8 in

Related product manuals

Poulan Pro PB22H46YT

Preview: LAWN TRACTOR PB22H46YT

LAWN TRACTOR PB22H46YT

Preview: Poulan Pro PB22H42YT

Poulan Pro PB22H42YT

Poulan Pro PB22H48YT

Preview: Poulan Pro PB20A46

Poulan Pro PB20A46

Poulan Pro PB2042YT

Poulan Pro PB20H46YT

Preview: Poulan Pro PB20A46YT

Poulan Pro PB20A46YT

Preview: Poulan Pro PB20H42YT

Poulan Pro PB20H42YT

Preview: Poulan Pro Pro PB20H42YT

Poulan Pro Pro PB20H42YT

Poulan Pro Pro PB26H54YT