Page 26 of 35 Reference: 708052-1 Issue date: 23-Jul-2014 Revision: B
REMOVING THE SECONDARY WIRE ROPE (OPTIONAL)
Make sure that the platform is
properly supported on a stable surface
before putting slack on the main
suspension wire rope to prevent hoists
and platform from tipping and causing
injury.
1. There should be no slack on
the main suspension wire rope.
2. Before the main suspension line
has been removed from the hoist,
remove the counterweight from the
end of the secondary wire rope.
3. Pull the secondary wire rope out of
the hoist by hand.
If you are removing both wire ropes from
the hoist on a stable surface, you must
remove the secondary wire rope before
removing the main suspension wire rope.
= Inspect
= Verify
=Perform process
To Next Page
Loading...