INTRODUCTION
The ASTRO E1500 is used to raise, support and lower suspended scaffolds, work cages and
bosun chairs on, or in buildings and structures. If used for any other purpose, you must take all
necessary precautions to be sure that both design and operation are hazard free, and such use
conforms with manufacturer’s specications.
Before using the ASTRO E1500, learn the procedures described in this manual. Any operation
in violation of these instructions may result in bodily injury or death. The design and
manufacturing of the ASTRO E1500 must comply with CAN/CSA -Z271-98 standards.
It is the duty of the employer to provide this manual to each operator.
Power Climber reserves the right to make changes or modications to its hoist. Users of this
equipment must request current operating information prior to using this equipment. Call your
local Power Climber dealer.
This manual is included with each ASTRO E1500. Additional copies are available from your
Power Climber dealer. Keep a current copy of this manual with the hoist at all times.
Page 5 of 35 Reference: 708052-1 Issue date: 23-Jul-2014 Revision: B
Features of the ASTRO E1500 Hoist
Feature Function Benet
Operating Range:
220V, +/-10%
• Proven reliable performance
from 198 to 242 run volts
• Tested in 30 min. continuous
run tests
• Reduces service calls
• Extends electric component life
• Eliminates power-induced down
time
• Allows longer drops with yoked
hoists
• Saves time and money ($)
Load Sensitive
Traction
• Applies only the traction
needed to lift load, not full
1,500 lbs (6.67 kN) lifting
force on rope
• Greater tolerance of wire rope
condition
• Saves wear and tear on rope, extends
wire rope life
• Saves costly wire rope jam in eld
To Next Page
Loading...