Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model number: PS-750L 05
Machine specifications
1. Speed control
2. Interlocking knob
3. Switch
4. Connection point vacuum cleaner
5. Allen key
6. Bottom plate
7. Saw buckle
8. Pendulum
9. Guard
10. Saw blade
11. Laser switch
12. Guide roller
13. Side guide
14. Dust extraction adaptor
Package contents
1 Jigsaw
4 Saw blades
1 Allen key
1 Parallel saw guide
1 Vacuum cleaner adapter
1 Instruction manual
1 Quick Start-guide
1 After Sales-card
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model number: PS-750L 20
Cutting in
Fig. 9
If the starting position of the workpiece is not on the side, or if no hole has
been drilled, you must cut into the surface. To do this, proceed as follows:
• Put the jigsaw on the rounded edge of the bottom plate.
• Switch on the appliance and slowly lower the jigsaw until it touches the
workpiece.
• Let the jigsaw cut into the workpiece gently without forcing it.
• When you are through the workpiece, take the jigsaw out of the hole.
• Place the appliance in the normal position into the surface and continue
the sawing.
You can also cut in by first drilling a hole into the workpiece. To do this, use a
bit that makes a hole big enough for the saw blade. Now you can carry out
the steps described under 'Sawing'.
Operation
To Next Page
Loading...
Need help?
General
