12
USING THE CONTROLLER WITH OTHER APPLICATIONS
1. Set up the controller on a plane, flat surface
2. You can connect a DJ microphone (balanced or unbalanced optionally via an XLR plug or a 6.3 mm plug to
the respective microphone input MIDI MIC on the front panel. Balanced cables provide +6 dB more output
and guarantee a better protection against interference in case of long cable runs. The microphone signal is
directly mixed to the signal sum.
3. For pre-fader listening to both decks of for monitoring the sum signal ahead of the output controls MASTER
CONTROL and BOOTH VOLUME, it is possible to connect stereo headphones optionally via a 6.3mm plug
to input HEADPHONE 1 or a 3.5mm plug to input HEADPHONE 2 on the front panel.
4. For connecting amplifiers, several stereo outputs with individual level controls are available:
- Connect the main amplifiers to the unbalanced RCA output MASTER and/or to the balanced XLR output
BAL OUT.
To Next Page
Loading...
