-13-
• Do not operate high power loads with the power inverter while watching television.
• Make sure that the antenna feeding your television provides an adequate (“Snow free”) signal
and that you are using good quality cable between the antenna and the television.
• Move the television as far away from the power inverter as possible.
• Keep the cables between the battery and the power inverter as short as possible and twist
them together with about 2 to 3 twists per foot. This minimizes radiated interference from the
cables.
2. Troubleshooting guide
Problem and Symptoms Possible Cause Solution
Low output voltage: Using average reading Use true RMS and cable.
110V : 95-105VAC Voltmeter See page 7, Point 6-7 of manual
220V : 190-210VAC
Load LED flashes Overload Reduce load. Remove Load.
Under Volt LED flash Low input voltage
Recharge battery, check
connections and cable.
Over Temp. flash Thermal shutdown Improve ventilation
N. Maintenance
Very little maintenance is required to keep your inverter operating properly. You should clean the
exterior of the unit periodically with a damp cloth to prevent accumulation of dust and dirt. At the
same time, tighten the screws on the DC input terminals.
WARNING!
Do not open or disassemble inverter. Attempting to service the
unit yourself may result in a risk of electrical shock or fire.
To Next Page
Loading...
