RECLINE
Reclining is adjusting the back angle of your chair while leaving the seat
angle unchanged. This is used whenever positioning of the back is
necessary while at the same time leaving the lower body position
unchanged.
The Supertilt Plus offers an optional manual recline that has to be
adjusted with a 14” Allen key. An Supertilt Plus recline kit is also
offered to upgrade a manual Supertilt Plus with automatic recline
capability.
To recline your chair squeeze the release handle and push downward on
the push handle until the required degree of recline is achieved. Then
release the handle and the chair will lock at this angle. Reclining could
be done as often as necessary.
To bring your chair back up to an upright position, squeeze the handle,
push upwards until back is upright then release the handle.
Your cylinder and release mechanism do not need any maintenance
though a regular cleaning of both is recommended. However the
cylinder shaft should always be clean and dry for it to function
efficiently.
Default Position
Manually Reclined
To Next Page
Loading...