BACK REST
Your Power Plus Mobility Back Rest is fully adjustable in height and
depth/angle. Your back rest also has built in quick release ability.
To Set Back Height:
Slightly loosen both bolts (4) Set back to desired height and tighten (4) to
lock into position.
To Set Back Depth/Angle:
Slightly loosen all three bolt screws (3) set back to desired depth/angle
and tighten (3) to lock into position
To Remove Back:
Push down on (2) on both sides of the back (it will remain open). Simply
push the back forward so the top locking pin (1) is out and clear from the
hardware plate (5). Then lift up and forward to clear the bottom locking
pin (1) from the hardware plate (5).
To Install Back:
Place the bottom locking pins (1) into the hook of the hardware plate. Do
this so both left and right bottom sides are into position. Then pull back
on the back rest into place. (2) will automatically lock. Ensure (2) is
locked securely before use.
# Description Quantity
1 Locking Pins 2
2 Release Handle 1
3 Depth Adjustments
(Bolts)
3
4 Height Adjustments
(Bolts)
2
5 Hardware Plate 1
1
4
3
5
2
To Next Page
Loading...