21
• Broken sheave or hub
• Loose or missing mounting bolts
• Bent or "out-of-round" condition (pulley not spin true
on shaft)
• Misaligned pulleys
1 – Drive Pulley
2 – Tension Pulley
3 – Auger Pulley
• Foreign material on pulleys, oil, grease, dirt, etc.
• Misaligned tension pulley
• Tension pulley loose or damaged
• Tension pulley and arm assembly operation
• Does the tension arm move freely both engage and
disengage directions without binding?
• Misaligned tension pulley, the pulley should move
parallel to the belt centered to the belt
• Check return spring operation and tension
Inspect the auger engagement handle and cable:
• Cable and connection damage
• Free movement (from engage to disengaged
positions)
• Binding or improperly routed cable
• Cable pulley(s) damage, misalignment and binding
• Cable adjustment plate damaged or improper
installation
• Handle damaged or binding at pivot
Storage
WARNING! Never store your Snow Thrower
for extended periods of time with fuel in the
tank. Fuel stabilizer can be added to the fuel to
extend its shelf life for storage.
Store the unit, in a locked, dry place out of the
reach of children to prevent unauthorized use or
damage. Cover loosely with a tarp for added
protection.
Cleaning
1. To clean your Snow Thrower, use a damp
cloth and mild detergent on the surfaces only.
Never get soap or water inside the working
mechanisms of your Snow Thrower.
Note: Do not clean with water. Water will
freeze due to low temperature and damage
the machine.
2. Clean the Snow Thrower of snow and ice
buildup before storing or transporting. Be sure
to secure the unit while transporting.
3. Inspect the Snow Thrower carefully for worn,
loose, or damaged parts. Check connections
and screws and tighten if necessary.
To Next Page
Loading...
Need help?
General
