Power smart PS8218 - User Manual

Questions and Answers

T
Tiffany SmithAug 4, 2025
Why is my Power smart PS8218 bar and chain running hot and smoking?
- J
  James HallAug 4, 2025
  If your Power smart Chainsaw's bar and chain are running hot and smoking, it could be due to several reasons. First, check if the chain tension is too tight and re-tension the chain. Another reason could be that the chain oil tank is empty, so fill it with bar and chain lubricant. Finally, check for any debris in the guide bar groove and clear it out.
A
ashley43Aug 10, 2025
What to do if Power smart PS8218 Chainsaw does not cut properly?
- J
  Jessica CoxAug 10, 2025
  If your Power smart Chainsaw isn't cutting properly, there are several potential causes. This could be due to insufficient chain tension, which requires readjustment. Another cause might be a dull chain, which means you should replace it. Also, check if the chain is installed backwards and reinstall it correctly. Other possible causes are worm or excessively stretched chain. Finally, check that the chain is in the bar groove and reinstall if necessary.
J
Johnny RobertsonAug 16, 2025
What to do if the Power smart PS8218 Chainsaw motor runs but the chain doesn't rotate?
- J
  johnsonstaceyAug 16, 2025
  If the motor of your Power smart Chainsaw is running but the chain isn't rotating, it could be because the chain does not engage the drive sprocket. Reinstall the chain, ensuring the drive links are fully seated on the sprocket. Another potential cause is the guide bar nose sprocket, in which case you should replace the guide bar.
S
Sean WilliamsAug 22, 2025
Why doesn't the chain brake engage on my Power smart PS8218 Chainsaw?
- L
  larrywilsonAug 22, 2025
  If the chain brake on your Power smart Chainsaw isn't engaging, it could be due to debris preventing full movement of the chain kickback brake handle. Clean any debris from the external chain brake mechanism. Another possible cause is a chain brake malfunction. Warning: operating a chainsaw without a functioning chain brake could lead to serious personal injury. Contact an approved service location before using.
S
stokesericaOct 28, 2025
How to fix a Power smart PS8218 Chainsaw when the motor doesn't run?
- J
  Justin BakerOct 28, 2025
  If the motor of your Power smart Chainsaw isn't running, several factors could be the cause. First, ensure the saw is properly plugged in. Check the cord for damage; if damaged, replace the extension cord or contact an approved service location if the chainsaw cord is affected. Verify the electrical outlet is functional by testing with another device. Make sure you are pressing the lock-off button before pressing the trigger switch. Also, ensure the chain brake is disengaged by pulling the chain kickback brake handle backward. If the chain is bound in wood, release the trigger, remove the chain, and restart. Finally, check for debris in the bar groove by pressing the chain against the wood and moving the chainsaw back and forth, or unplug the saw, remove the side cover, and clean out any d...