Page No. 12
Issue Date: Rev 14 28 May 2012
Operating Instructions Form No. 102842
PROBLEM CAUSE SOLUTION
Pump handle operates with a
spongy action.
1. Air trapped in system. 1. Position cylinder lower
than pump. Extend and
return cylinder several
times. Follow bleeding
instructions.
2. Too much uid in reservoir. 2. Check uid level per
instructions.
Pump handle effort drops
signicantly after some pres-
sure has been obtained.
1. This is normal operation on
most two-stage hand
pumps.
*Power Team recommends these hand pump repairs be performed by an Authorized Hydraulic
Service Center.
To Next Page
Loading...
