Page No. 3
Issue Date: Rev 14 28 May 2012
Operating Instructions Form No. 102842
SAFETY EXPLANATIONS
Two safety symbols are used to identify any action or lack of action that can cause person-
al injury. Your reading and understanding of these safety symbols is very important.
DANGER
Danger is used only when your action or lack of action will cause serious human injury or
death.
WARNING
Warning is used to describe any action or lack of action where a serious injury can occur.
IMPORTANT
Important is used when action or lack of action can cause equipment failure, either imme-
diate or over a long period of time.
1. Pictogram Denition
Do not remove this component. For service only. Pressure must be released.
WARNING
It is the operator’s responsibility to read and understand the following safety statements,
• Only qualied operators should install, operate, adjust, maintain, clean, repair, or trans-
port this machinery.
• These components are designed for general use in normal environments. These com-
ponents are not specically designed for lifting and moving people, agri-food machin-
ery, certain types of mobile machinery or special work environments such as: explo-
sive, ammable or corrosive. Only the user can decide the suitability of this machinery
in these conditions or extreme environments. Power Team will supply information
necessary to help make these decisions.
• Do not use equipment if damaged, altered, or in poor condition.
• All safety decals must be replaced when unreadable.
These instructions are intended for end-user application needs. Most problems with new equipment are caused by
improper operation or installation. Detailed service repair instructions or parts lists can be obtained from your nearest
Power Team facility.
To Next Page
Loading...
