- 18 -
WIFI Controller Function Specification
1、Android WIFI Module Set Up Steps：
Scan the QR code to download or use the below link:
https://fir.im/124b to download and operate based on below steps .
Step 1：
Turn it on，when the drive by wire controller is out of full screen，buzzer rings
a sound like “Di”, it shows to be in the AP mode. Only when being in the AP mode,
the heat pump can be equipped with the WIFI module；
Enter the AP mode by hand（Press the button of
+ +
for 3 seconds in the
same time. When entering the AP mode, the button is twinkling；
Step 2：
Turn on the WIFI on phone and get it connected to the WIFI hot spot，the WIFI hot
spot should be connected to the internet，show on the picture：Connected to WIFI
hot spot“TP-LINK_1906”；
To Next Page
Loading...