17
NOTE: The blade rotation direction needs be the same as the
picture below. Use the screwdriver to hold the flange and tighten
the nut counter-clockwise, ensure the nut is tightened sufficiently.
WARNING!
Make sure the cutting head has been assembled correctly
before use!
Fit the strap
The brush cutter must be used with the harness provided.
1. Put the left and right straps over the shoulders and secure with
the quick-connect function of the harness. The finished set up
should resemble the picture below.
Note: At the front of the harness there is an easily accessible
quick-release function. Use the quick release in any emergency
situation that requires you to free yourself from the machine and
harness.
To Next Page
Loading...