31
Lubricate angle transmission
Lubricate with lithium-based grease. Remove the screw and put in
the grease, turning the shaft manually until grease emerges, then
replace the screw.
Storing the unit
After cutting, clean the unit thoroughly. Store the unit in a dry
room, allowing the motor to cool down beforehand.
Transport
Due to safety reasons, please see to it that the cutter is
transported free of oil and gas!
Worn parts
Even when used in the intended way, some components are
subject to normal wear. They will have to be replaced depending
on the duration of usage. These parts include, among others, the
cutting tool and the retaining disk.
WARNING! Use only the original manufacturer’s
replacement parts, accessories and attachments. Failure
to do so can cause poor performance, possible injury and
may invalidate your warranty.
Replacement parts/accessories:
For the cutting listed here, you can always use the safety guards
provided with the unit.
Machine/brush cutter:
Spool with Ø 420 0184201086
Blade with 3 teeth Ø 255 x 1.4 0184201087
Safety shield for machine 0184201081
To Next Page
Loading...