19
Warning!
Do not use force when installing the battery pack. If the
battery pack does not slide in easily, it is not being inserted
correctly.
Verify that the switch is in the OFF position before inserting
or removing the battery pack.
Verify that the battery pack has been removed and the
switch is in the OFF position before inspecting, adjusting or
performing maintenance on any part of the brush cutter.
Read, understand and follow the instructions contained in
the section entitled charging procedure.
Charging the battery pack
NOTE: The battery pack comes partly charged. Charge the
battery pack prior to first use, ideally at least 60 minutes.
. Always pull out the plug of charger from the mains before
removing or connecting the battery pack to the charger.
. Never charge the battery pack when the ambient
temperature is below 0 °C or above 45°C.
. Never recharge a battery pack again immediately after
rapid charging. This could overcharge the battery pack,
thus reducing the lifespan of the battery pack and
charger.
. Rest the charger for at least 15 minutes between
continuously charging sessions.
. If no battery pack is inserted into the charger and the
charger is connected to mains, the charging status LED
shows red.
NOTE: Always fully charge the two batteries at same time.
Checking battery capacity
Press the battery capacity level button to check the charging level of
the battery pack. The status/remaining charge will be shown on the
battery charging level indication light.
To Next Page
Loading...
