15
Assembly
WARNING! Always take care when removing the
packaging to prevent causing damage to the machine.
1. Remove all parts of the brush cutter from the box and carefully
remove all packaging. Take care not to lose any instructions
which may be affixed to the parts. These provide important
information which will be required when assembling the brush
cutter.
2. Keep all packaging until the brush cutter is fully assembled
and has been operated successfully.
NOTE: Always recycle the packaging in accordance with local
recycling schemes.
Assemble the operation handle
Release the inner hex screws and remove the upper cover of the
handle holder.
Put the handle on the handle holder (match the hole on the
handle to the cylinder on the holder).
To Next Page
Loading...
