25
Cleaning and storage
After use, remove the battery pack from the trimmer.
When not in use, store the machine in a dry, safe place, out of the
reach of children.
Use only manufacturer recommended replacement parts and
accessories.
To clean the tool, remove the battery pack and use a mild soap
solution and a damp cloth to clean it. Do not immerse the tool in
water or spray it with a hose. Do not allow any liquid to get inside it.
Do not clean with a pressure washer.
Troubleshooting
Suspected malfunctions are often due to causes that the user
can fix themselves.
Therefore, check the product using this section. In most cases the
problem can be solved quickly.
WARNING! Only perform the steps described within
these instructions! All further inspection, maintenance
and repair work must be performed by an authorised
service centre or a similarly qualified specialist if you
cannot solve the problem yourself! Gloves and appropriate
protective clothing must be worn when performing these
instructions.
Fault Possible cause Solution
Product does
not start
Not connected to power
supply
Connect to a proper power
supply.
Power cord or plug is
defective
Call after sales support at
01904 727509
Other electrical defect to
the product
Call after sales support at
01904 727509
Product does
not reach full
power
Extension cord is not
suitable for this product
Use a proper extension
cord
Power source (e.g.
generator) has too low a
voltage
Connect to another proper
power supply
Air vents are blocked Clean the air vents
Unsatisfactory
result
Line spool does not have
sufficient line
Lengthen cutting line or
exchange a new spool
Line has not been
conducted out of the
spool or only one seide
Remove spool and place
line through opening
outwards
To Next Page
Loading...
