EasyManua.ls Logo

PowerBase 577178 - Operation; Charging the battery pack

PowerBase 577178
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
Operation
Charging the battery pack
NOTE: The battery pack comes partly charged. Charge the
battery pack prior to first use, ideally at least 60 minutes.
Always pull out the plug of the charger from the mains
before removing or connecting the battery pack to the
charger.
Never charge the battery pack when the ambient
temperature is below 0°C or above 45°C.
Never recharge a battery pack again immediately after
rapid charging. This could overcharge the battery pack,
thus reducing the lifespan of the battery pack and
charger.
Rest the charger for at least 15 minutes between
continuously charging sessions.
If no battery pack is inserted into the charger and the
charger is connected to mains, the charging status
LED shows red.
NOTE: Always fully charge the two batteries at the same
time.
Checking battery capacity
Press the battery capacity level button to check the charging level
of the battery pack. The status/remaining charge will be shown on
the battery charging level indication light.

Related product manuals