WHEN ADDING PETROL TO WATERBLASTER, OBSERVE THE FOLLOWING:
• DO NOT use unapproved petrol such as E85 (85% ethanol/15% petrol).
•
DO NOT mix oil with petrol.
•
DO NOT modify engine to run on alternate fuels.
• Turn Waterblaster
OFF and let it cool for at least two minutes before removing
petrol cap. Loosen petrol cap slowly to release pressure.
• Keep petrol away from sparks, open flames, pilot lights, heat and other ignition
sources.
•
DO NOT light a cigarette or smoke near open petrol tank or container.
• Clean area around petrol fill cap and slowly remove cap to allow any pressure to
escape.
• Install petrol cap and allow any spilled petrol to evaporate before starting
engine.
•
DO NOT overfill petrol tank. Slowly add unleaded petrol (A) to petrol tank (B).
Use extreme caution not to fill petrol above baffle
(C). This allows appropriate
space for petrol expansion.
USING WATERBLASTER AT HIGH ALTITUDES
Engine Carburetor is factory adjusted for optimum operation from 0 to 1500 meters
above the sea level. Approximately 10 % of power drop in the engine is expected
with respect to each 1000 meters of altitude. To maintain proper emissions compli-
ance and optimum performance & petrol consumption, high altitude adjustment
may be required for altitudes above 1500 meters. If adjustment is required call
Customer Ser
vice at 1-888-278-8092.
STARTING
PRIOR TO STARTING THE W
ATERBLASTER, MAKE SURE THAT YOU HAVE:
1. Selected a proper size nozzle for the job at hand (see "SELECTING THE RIGHT
NOZZLE")
2. Attached the Waterblaster to the water source and turned on the source (see
"ATTACHING THE PUMP TO WATER SUPPLY").
20
To Next Page
Loading...