6. Allow detergent to "soak in" for 3-5 minutes before washing and rinsing.
Reapply as needed to prevent surface from drying. Do
Not allow detergent to
dry on surface (prevents streaking).
TO RINSE:
1. Please refer to the correct way to replace with an appropriate high pressure
nozzle (see "SELECTING THE RIGHT NOZZLE"). Squeeze the trigger and wait for
the detergent to clear.
2. Keep the spray gun a safe distance from the area you plan to spray.
3. Apply a high pressure spray to a small area, and then check the surface for
damage. If no damage is found, it is okay to continue cleaning.
4. Start at the top of the area to be rinsed, working down with same overlapping
strokes as you used for washing and applying detergent.
TO FLUSH SYSTEM
When you have completed the use of detergent injection system:
1. Turn off the engine and fill the detergent tank with clean water.
2. Remove the nozzle and then turn engine back on.
3. Point the wand toward a safe direction and squeeze the trigger to flush clean
water through the detergent tank and the system until it is thoroughly clean.
Leaving chemicals and cleaning solutions inside the
pressure pump could damage it.
Damages created by leaving soaps, chemi-
cals and cleaning solutions inside the pump can void the warranty.
CLEANING TIPS:
• Never use the Waterblaster water inlet to siphon detergent or wax.
• If you have the nozzle too far away from the surface being washed, the cleaning
will not be as effective.
I
MPORTANT: DO NOT get closer than 0.15 meters when cleaning.
SHUTTING DOWN
1. To stop the engine, set the engine switch on the side of the engine to OFF position.
2. Slide Petrol Valve lever to the left to stop petrol flow to the engine.
3. Turn off the water supply, Squeeze the Gun trigger to release any remaining water in
the system then disconnect garden hose from the Water blaster.
4. Store Spray Gun on the side and hoses inside the hose housing inside the handle.
5.
CAUTION - Allow engine to cool down before folding handle.
24
To Next Page
Loading...