Removable Faceplate Remote
Control
1.
Remove the screws that attach the panel (Keep the screws safe)
2.
Follow the diagram below to connect the panel and supplied extension cord.
Operation
1.
Turn
ON the inverter: Press the
ON/OFF switch on the front panel for 1 second.
2.
Turn
OFF the inverter: Press the ON/OFF switch on the front panel for 1 second.
3. When you have confirmed that the appliance to be operated is turned off,
plug
an
appliance cord into one of the
11
OV
AC
Outlets on the front panel
of the inverter.
4.
Turn
ON
the inverter.
5.
Turn
the appliance ON.
6.
Plug
in
additional appliances and turn them
ON.
Note:
When using
an
extension cord from the inverter to an appliance the
extension cord should not be longer than 50
feet.
TELEVISION AND
AUDIO SUGGESTIONS
Although all PowerDrive
TM
inverters are shielded and filtered to minimize signal
interference, some interference with your television picture may be unavoidable,
especially
in
weak signal areas.
Here are some suggestions that may improve reception:
1. First, make sure that the television antenna produces a clear signal unqer
normal operating conditions. Also, ensure that the antenna cable is properly
shielded and
of
good
quality.
2. Change the position
of
the inverter, antenna cables or
TV
power cord.
3. Isolate the
TV,
its power cord and antenna cables from the 12-Volt power
source by running an extension cord from the inverter to the television set.
4.
Coil the television power cord and the input cables running from the 12-Volt
power source to the inverter.
5. Attach a "Ferrite Data Line
Filter"
to the television power cord. More than one
filter may be required.
These filters are available at most electronic supply stores.
To Next Page
Loading...
Need help?
General
