16 GB
result, which is shown at the bottom of the
display, is saved in the device
10
.
Press the MODE button
8
briefly. The de-
vice is now ready to measure the next surface
area or volume.
Measure the next surface area or volume in
the same way as you performed the first
measurement.
Now press the RECALL button again to adopt
the new result into the aggregate memory.
The result of the addition is shown in the
bottom line of the display.
If you would like to add further surface areas
or volumes, repeat steps 3 to 5.
Hold the MODE button pressed down for
3 seconds in order to leave the Addition
mode.
Displaying the last
measured values
After you have measured a surface area or a
volume, press the READ button
4
repeatedly
in order to display the individual values of the
measurement.
The symbol of the corresponding measured
value flashes, and the measured result is
shown in the top line of the display.
Temperature display
Hold the FT/M button
3
pressed down for
approx. 3 seconds. The current room temper-
ature, in the official °C temperature unit, is
shown in the display
10
.
To Next Page
Loading...
