6
PREPARATION
and) To open the packaging and remove the device. and) To open the packaging and remove the device.
b) Remove the protective film and the transport protection (if any). b) Remove the protective film and the transport protection (if any).
c) Check whether the package parts are removed and keys. c) Check whether the package parts are removed and keys.
d) Check the device and the equipment was not damaged during transport. d) Check the device and the equipment was not damaged during transport.
e) Keep the packaging. e) Keep the packaging.
ATTENTION! The device and packaging are not toys! Keep away from children, danger of choking or suffocation.ATTENTION! The device and packaging are not toys! Keep away from children, danger of choking or suffocation.
INSTALLATION AND OPERATION
engine assembly
Mounting the motor with the drive takes place by means of four screws (point 34 on the print). Then, the throttle cable
to be installed along with the throttle on the handle.
Refueling
Attention! The use of leaded gasoline can cause engine damage. Use only unleaded gasoline 95.
Refueling fuel engine when the engine is on the boat can lead to pollution of water body or water can damage the
skin. Therefore, refueling on the boat is categorically prohibited.
To avoid the trip after refueling, make sure that the engine is bolted to the transom well.
To Next Page
Loading...
Need help?
General
