7
Starting a cold engine
ATTENTION! The default engine is not flooded with oil. Before commissioning pour motor oil. Then you
should regularly check the oil level.
and) Loosen the bleed screw on the fuel tank by turning it 2-3 full turns. and) Loosen the bleed screw on the fuel tank by turning it 2-3 full turns.
b) Switch / move (depending on model) switch (6) on the handle to the "I" position. b) Switch / move (depending on model) switch (6) on the handle to the "I" position.
c) Gently push the primer pump several times (7 - 10 times) until fuel comes into the primer and c) Gently push the primer pump several times (7 - 10 times) until fuel comes into the primer and
will be in the carburetor.
d) Move the lever (12) to close the choke ( upper position).d) Move the lever (12) to close the choke ( upper position).d) Move the lever (12) to close the choke ( upper position).
e) Pull on the starter handle (13) until the initial engine start-up. e) Pull on the starter handle (13) until the initial engine start-up.
f) Move the lever (12) to open the choke ( in the lower position) - ( excessive f) Move the lever (12) to open the choke ( in the lower position) - ( excessive f) Move the lever (12) to open the choke ( in the lower position) - ( excessive f) Move the lever (12) to open the choke ( in the lower position) - ( excessive
keeping the engine with closed suction factorial cause flooding or hinder its proper launching).
g) Pull the starter handle to start the engine proper ( "Engine enters g) Pull the starter handle to start the engine proper ( "Engine enters g) Pull the starter handle to start the engine proper ( "Engine enters
RPM ").
h) Allow the engine to warm up for a few minutes before you start work. h) Allow the engine to warm up for a few minutes before you start work.
Starting warm engine
• If you did not return the fuel from the carburetor to the fuel tank and the engine is still warm, pull starter
handle (13) one to three times, the engine should start.
Lacked FUEL / REBOOT:
• If you run out of fuel and the addition of its engine will not start / cooled engine, start the steps from 3 to
7 STARTING A COLD Sinik.7 STARTING A COLD Sinik.
TURNING OFF Sinik:
• Slide the switch in the handle to "O".
Check before departure
Before embarking on any journey carrying the motor control of the state.
and) Make sure that you have enough fuel for the planned expedition. and) Make sure that you have enough fuel for the planned expedition.
b) Check all bolts and nuts for tightness. b) Check all bolts and nuts for tightness.
c) Check if you have enough life jackets. c) Check if you have enough life jackets.
flushing the engine
After each use of the motor in sea water or polluted water, or if the engine is stored over a long period of time should
be washed with clean water. Failure to do so will result in the salt which entered the engine will produce corrosion
shortening the life of the unit.
In addition, you need to pay attention to the condition of the engine cooling fins. In the case of soil, dirt or mud is
impaired heat transfer through the engine is necessary to clean contaminants from the ribs.
To Next Page
Loading...
Need help?
General
