10
e) Check that the spark plug washer is in good condition and replace the candle by hand to prevent e) Check that the spark plug washer is in good condition and replace the candle by hand to prevent
turning the thread.
f) After the initial manual screwing the spark plug wrench to tighten the spark to carefully push f) After the initial manual screwing the spark plug wrench to tighten the spark to carefully push
washer .If installing new spark plug, tighten after screwing it manually key 1/2 turn to compress the washer.
If you are installing a candle used, tighten it with a wrench 1/8 to 1/4 turn. If the spark plug is tightened too If you are installing a candle used, tighten it with a wrench 1/8 to 1/4 turn. If the spark plug is tightened too
lightly, it may overheat and damage the engine.
g) Replace the spark plug. g) Replace the spark plug.
ATTENTION! Removing the hot candle head made of light alloy, and the cold screwing the candle in a hot head may ATTENTION! Removing the hot candle head made of light alloy, and the cold screwing the candle in a hot head may
cause damage to the threads of the sockets candles. In addition, cold candles in a hot head screwed tight and often
do not give up when heated to remove. Ideally, the temperature was close to the candle head temperature in which
they will be screwed.
Replacing the oil in the gearbox screw
Oil in the gearbox should be replaced after a maximum of 100 hours.
and) Empty oil reservoir by unscrewing the oil drain plug and a level plug. and) Empty oil reservoir by unscrewing the oil drain plug and a level plug.
b) After pouring the engine oil must be filled with new gear oil, should be added until the b) After pouring the engine oil must be filled with new gear oil, should be added until the
sailing the oil stopper.
c) Replace the plug and the level plug and tighten them. c) Replace the plug and the level plug and tighten them.
Propeller
The propeller may be exposed to mechanical damage from impact against the bottom or objects in the water during
operation of the engine. Not even the big engine damage can affect the culture of work and boat speed. The screw is
fitted with a special pin which is designed in such a way alb burst in case of impact against a hard object. Replacing
the pin is very simple.
To Next Page
Loading...
Need help?
General
