8
Cleaning the fuel tank
Remove the cover of the fuel filter, empty fuel tank, the fuel filter pull out and remove the water, mud and other debris
by rinsing tank chemicals.
Fuel tank cleaning should be done once every six months.
Maintenance of the fuel filter
Download the spark plug, fuel tank Delay. Pull out the fuel filter and clean it (if necessary, replace with a new one).
Fuel filter maintenance should be performed every 20 hours of operation.
In the event of flooding the engine
A motor that has flooding must be immediately subjected to detailed inspected in the workshop, to prevent corrosion.
In the event of flooding, the engine should immediately do the following:
1. Remove the engine cover and rinse with clean water. 1. Remove the engine cover and rinse with clean water.
2. Disconnect the spark plugs and remove the plugs. 2. Disconnect the spark plugs and remove the plugs.
3. Disconnect the fuel lines, empty and clean the fuel tank and fuel lines. 3. Disconnect the fuel lines, empty and clean the fuel tank and fuel lines.
4. Put the engine in the horizontal position (holes spark plug down), slowly spinning wheel 4. Put the engine in the horizontal position (holes spark plug down), slowly spinning wheel
the flywheel to get rid of water from the system (about 20 rpm)
5. Empty the carburetor: the engine to vertical position, remove the carburetor and clean it. 5. Empty the carburetor: the engine to vertical position, remove the carburetor and clean it.
6. Clean the starter, all the electrical connectors and electrical components, if necessary 6. Clean the starter, all the electrical connectors and electrical components, if necessary
rinse with clean, fresh water. Then, using compressed air to blow the remaining water and dry thoroughly
before assembly.
7. Verify that the sand and dirt from entering the engine (sand under the cover 7. Verify that the sand and dirt from entering the engine (sand under the cover
engine, disturbing sound while turning the flywheel. In this case, it is forbidden to start the engine. It
should then spin the engine and get rid of all impurities.
8. After drying of the engine and its components must be made whole. Put the engine in the sweet8. After drying of the engine and its components must be made whole. Put the engine in the sweet
water and let it run idle for 30min.
9. If the engine does not start, re-download spark plugs and check if the water is not present on the
electrodes. If water is present to blow her candles and reinstall with cables, if there is a need to replace
them with new ones.
In case of problems, please contact an authorized service center.
Checking spark plug
At the spark plug may appear greasy black coat. This can cause a problem with the firing of the engine and correct or
even prevent the starting of the engine.
The spark plug should be checked every 20 hours of operation or at least once a month. If the plug is dirty, clean it or
replace it with a new one.
If the motor rotates but does not start, check that the candle gives a spark.
You can check the spark plug special tester or by the following method.
• Make sure that you are in a well-ventilated area, free of fuel vapors.
• Remove the spark plug from the engine and connect it to a pipe plug.
To Next Page
Loading...
Need help?
General
