Figure 8 Figure 9
11
Operation
• Save all instructions
Pre-Start Inspection
A
1. Make sure all safety guards are in place and all nuts and
bolts are secure.
2. Check oil level in engine crankcase. See your engine
3. Inspect air cleaner for cleanliness. See your engine
manual for procedure.
4. Check the fuel supply. Fill the fuel tank no closer than 1
inch from top of tank to provide space for expansion. See
your engine manual for fuel recommendations.
5. Be sure spark plug wire is attached and spark plug is
tightened securely.
6. Examine underneath and around engine for signs of oil or
fuel leaks.
7. Inspect fuel hoses for tightness and fuel seepage.
8. Look for signs of engine damage.
9.
10. Remove any debris from tines and tine shafts.
11. Move the tiller to the area of operation.
12. Check position of wheels swing plate should be in the tilling
mode position.
13. Check drag bar position.
IMPORTANT:
OIL. YOU MUST ADD ENGINE OIL BEFORE STARTING
ENGINE.
CAUTION
-
-
ENGINE.
WARNING
OR RUNNING. ALWAYS MOVE OUTDOORS TO FILL TANK.
DANGER
-
Start the Engine
B
1. Press ON/OFF switch to ON position. (See Figure 10)
2. Push primer bulb 3 times. Wait 2 seconds between each push. (See Figure 8)
3. Place left hand on upper handle. (See Figure 9)
4. Grasp starter handle and pull out slowly, until it pulls slightly harder. (See Figure 9)
5. Pull rope with a rapid full arm stroke until engine runs.
6. After engine starts running, move choke lever to the appropriate position.
Questions? Call Toll Free at 1-800-737-2112 Copyright © 2011 MAT Engine Technologies, LLC
To Next Page
Loading...
