Powermatic 209 User Manual

Operating Instructions and Parts Manual
20-inch Planer
Models 209 and 209HH
WMH TOOL GROUP
2420 Vantage Drive
Elgin, Illinois 60124 Part No. M-0260283
Ph.: 800-274-6848 Revision D1 11/06
www.wmhtoolgroup.com Copyright © WMH Tool Group
This Manual is Bookmarked

Powermatic 209 Specifications

General

Motor Power	5 HP
Planing Width	20 inches
Feed Rate	24 and 31 FPM
Maximum Cutting Width	20 inches
Voltage	230V
Phase	1 Phase
Cutterhead Speed	5, 000 RPM
Number of Knives	4
Type	Planer
Maximum Cutting Depth	1/8 in
Minimum Stock Length	10 in

Summary

Warnings

Specifications

Assembly

Electrical Connections

Guidelines for safely connecting the machine to power.

Adjustments

Belt Tension

Table Rollers

Cutterhead

Knife Adjustments (Model 209 only)

Detailed steps for setting and adjusting cutterhead knives on Model 209.

Replacing and Re-setting Knives (Model 209 only)

Process for removing, sharpening, and reinstalling knives on Model 209.

Replacing or Rotating Knife Inserts (Model 209HH only)

Method for rotating or replacing knife inserts on Model 209HH.

Work Table Parallel to Cutterhead

Procedure to ensure the work table is parallel to the cutterhead.

Anti-Kickback Fingers

Maintenance and inspection of safety anti-kickback fingers.

Infeed and Outfeed Roller Spring Tension

Height of Infeed Roller, Chipbreaker, Pressure Bar and Outfeed Roller

Crucial height relationships for planing components.

Outfeed Roller Height

Infeed Roller Height

Chipbreaker Height

Pressure Bar Height

Feed Speed Control

Depth of Cut

Maintenance

Lubrication

Electrical Connections – Single Phase, 230 Volt only

Electrical Connections – 3 Phase, 230 Volt only

Electrical Connections – 3 Phase, 460 Volt only

Preventive Maintenance