4. Method for Replacing Fuse
Pull out the power plug from power socket as shown in the step1 of left picture. Remove the safety
socket from the power socket with a straight screwdriver as shown in the step2 of left picture.
Take out the fuse according to the direction shown in the picture, and insert it after replacing it.
Note: the machine fuse insurance tube specifications for 250V/10A cP5*20mm
5. Folding Handle Strength Adjustment
The machine was set to a slightly more
suitable level of tension when finishing
production, but due to the different
personal wrist strength, users can adjust the
folding handle properly to their own taste.
Do not put it too loose. a loose play leads to
a large distance between the riser and the
host of the folding position, producing a
jarring phenomenon, cut out the round
rubber stopper at the bottom of the riser, as
shown in box 1 above. Combine the Allen
key and the socket wrench to a labor-saving
one levers, as shown in the oblique
branches. insert the Allen key into the lower end hole of the left riser and secure the hex nut.
Rotation in the clock means fast. otherwise it is a bit too loose.
To Next Page
Loading...
