Safety lock function
Pull off the safety lock in any state, window display "E07" And the buzzer bi-bi-bi three times.
The motor is stopped immediately if the motor is working.
You can't start again when the safety lock falls off.
Power saving mode
This system has the function of power saving. The system will enter the mode of power saving if
there is no keystroke command within 10mins in the standby state, display automatically turn off,
let can be woken up when any key is pressed.
8. Common Failures and Processing Method
Please call our dealer or our after-sales service if you have any other questions
Questions Possible causes Maintenance methods
Treadmill don't work
Not connected Put plug to insert socket
Power is not turned
on
Put the power switch in position “on"
Safety lock drop Put the safety lock in correct position
Circuit signal system
break
Check the controller input terminal and
signal circuit
The fuse blew out Replace fuse
The running belt doesn't run
smoothly
Insufficient
lubrication
Add silicone oil lubricant
Belt is too tight Adjust belt tightness
Running belt slipped
Running belt too
loose
Adjust running belt tightness
Running belt too
tight
Adjust running belt tightness
Error messages on electronic meter and elimination methods
Questions Possible cause Maintenance methods
0.00E+00 Poor communication The signal line is not plugged it. Plug it again
0.00E+00 Power assault
Power tube breakdown, replacement of electronic
control
0.00E+00 Non-sensing signal
Sensing wire is not plugged in properly. Plug it
again correctly
0.00E+00
Controller or motor
abnormal
Overload, replace controller or motor
To Next Page
Loading...
