good to be too tight. It is easy to increase the load of the motor and damage the motor, running
belt and roller etc.
Running Belt Deviation Adjustment
All treadmills need to be adjusted the running belt before delivery and after installation. But the
running belt may be deviated after a period of use which may be caused by the following reasons.
1. The main body is not placed smoothly.
2. The feet of users are not in the centre of the running belt.
3. The feet of users are uneven force
It will be returned to normal after a few minutes of no-load rotation if deviation is caused by man-
made. It should be adjusted with 6mm wrench at a half circle as the unit for deviation of non-
recover automatically.
Please adjust left bolt with clockwise or right bolt with counter clockwise if running belt is left
deviation.
Please adjust right bolt with clockwise or left bolt with counter clockwise if running belt is right
deviation.
The running belt deviation is not within the scope of warranty. And it is mainly maintained by the
user according to the manual. Running belt deviation will seriously damage the running belt. The
users must be found and corrected in time.
Adjustment of the motor belt (as shown on the right)
All treadmills have been adjusted before leaving the factory and after installation. However, after
a period of use, there may be slack and slipping, which is mainly adjusted by the user.
To Next Page
Loading...
