PowerPac PPBF555 - How to Clean; Problem Solving

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Turn the Temperature Control Rotary Knob to “OFF”, switch off the appliance and
unplug the socket from the electric mains before cleaning or conducting
maintenance. Open the door of the appliance.
Wait until the interior of the appliance has completely warmed up, and the
compressor cooled down, before cleaning or performing any maintenance
operation.
If the interior of the appliance is covered with a layer of frost, defrosting needs to be
carried out. Not performing this action may lead to an increase in electricity
consumption and a lessening of the effects of refrigeration.
DO NOT use electrical devices (e.g. hairdryers, heaters, radiators, fans, etc. to melt
ice), mechanical devices (sharp knives, ice-picks, etc. to scrape ice), a direct flame or
by any other means to remove ice from the interior surfaces) when defrosting.
After defrosting, clean the interior of the appliance with a soft, damp cloth. If
necessary, you can use a cloth moistened with mild liquid detergent. DO NOT use
abrasive scouring pads or powders.
Wipe the exterior of the appliance using a soft, damp cloth or sponge. Remove
stubborn spots with a cloth moistened with mild liquid detergent. DO NOT use
abrasive scouring pads or powders.
DO NOT soak the appliance in water or other liquids, wash it under the tap, or let
any liquid flow into the internal casing of the appliance to prevent electric shock
After cleaning, dry every surface using a soft cloth before restarting the appliance.
Remove dust and grime from the Condenser to keep it in good working order.
Rubbing some talcum powder on the gasket of the Freezer Door may help prolong
its life.
HOW TO CLEAN
PROBLEM SOLVING
The plug of the appliance is not inserted into the power socket.
Insert the plug into the grounded power socket and switch it
on.
The circuit breaker tripped or the fuse is blown.
Check the household circuit breaker for any tripped wires.
Call for a qualified electrician.
The Temperature Control Rotary Knob was set at too high a
temperature.
Set the Temperature Control Rotary Knob to between 3~4.
The appliance
does not work
7