Powerplus POWX0520 - 10 Cleaning and Maintenance; Cleaning; Lubrication; 11 Technical Data

POWX0520 EN
Copyright © 2022 VARO P a g e | 8 www.varo.com
10 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
10.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10.2 Lubrication
From time to time, apply a drop of oil to the thread of the lock screw (18).
11 TECHNICAL DATA
Voltage / frequency
230-240 V / 50 Hz
Power input
1500 W
No load speed
5500 min
-1
Saw blade
Ø 185 x Ø 20 x 2.4 mm
Max. depth of cut 90°
64 mm
Max. depth of cut 45°
48 mm
Mitre angle
0 – 45°
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
104 dB(A)
Acoustic power level LwA
115 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
2,4 m/s²
K = 1.5 m/s²
13 SERVICE DEPARTMENT
▪ Damaged switches must be replaced by our after-sales service department.
▪ If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).