Powerplus POWX07551T - Page 2

POWX07551T EN
Copyright © 2016 VARO P a g e | 2 www.varo.com
8.13 Mitre scale (Fig. 17) ............................................................................................. 12
8.13.1 To adjust mitre angles............................................................................................ 12
8.13.2 Mitre angle pointer adjustment ............................................................................... 12
8.14 Adjusting fence squareness (Fig. 18) ................................................................. 12
8.15 Setting cutting depth (Fig. 19)............................................................................. 12
8.16 Maximum cutting depth (Fig. 19) ........................................................................ 13
8.17 The laser guide (Fig. 20) ...................................................................................... 13
9 OPERATION.................................................................................. 13
9.1 Basic saw operations .......................................................................................... 13
9.1.1 Turning the laser guide on (Fig. 21) ....................................................................... 13
9.1.2 Turning the saw on (Fig. 21) .................................................................................. 13
9.2 Sliding carriage system (Fig. 22) ........................................................................ 14
9.3 Mitre cut (Fig. 23) ................................................................................................. 14
9.4 Bevel cut (Fig. 24) ................................................................................................ 14
9.5 Compound cut (Fig. 25) ....................................................................................... 14
9.6 Slide cutting wide boards (Fig. 26) ..................................................................... 14
9.7 Cutting bowed material (Fig. 27) ......................................................................... 15
9.8 Cutting grooves (Fig. 28) ..................................................................................... 15
9.9 Auxiliary wood fence (Fig. 29)............................................................................. 15
10 CLEANING AND MAINTENANCE ............................................... 15
10.1 Cleaning ............................................................................................................... 15
10.2 Replacing carbon brushes (Fig. 30) .................................................................... 16
10.3 Lubrication (Fig. 31)............................................................................................. 16
11 TECHNICAL DATA ....................................................................... 16
12 NOISE ............................................................................................ 16
13 TROUBLESHOOTING .................................................................. 17
13.1 Motor .................................................................................................................... 17
13.2 Saw operation ...................................................................................................... 17
14 SERVICE DEPARTMENT ............................................................. 17
15 STORAGE ..................................................................................... 18
16 WARRANTY .................................................................................. 18